bms_u025_brick_voltage_limit
Safe to driveTesla · BMS system
Battery Management System — Maximum Cell Voltage Lowered Due to Pack Wear
What it means
As a battery pack ages, the BMS quietly lowers the maximum voltage it allows each cell group ("brick") to reach. This alert simply records that accumulated wear has crossed a threshold where that limit was reduced from its original value. It's mainly informational — a sign the pack is aging as expected.
Symptoms
- Usually no obvious symptom — this is a logging/service alert
- Slightly reduced maximum range compared with when the car was new
- May coincide with other age-related BMS alerts
Likely causes (by probability)
- 1.Normal battery aging and accumulated cycle wearHigh
- 2.Frequent DC fast charging or sustained high states of charge accelerating wearMedium
What you can check yourself
- 01Track your displayed range at a given charge level over time to understand real-world degradation.
- 02If you use Scan My Tesla, note the pack's capacity readings for your records or a warranty discussion.
- 03Mention it at your next service visit, especially if degradation seems rapid for the car's age and mileage.
EV systems involved in bms_u025_brick_voltage_limit
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Severity
This is the car managing normal battery aging, not a failure. Keep an eye on overall range loss and raise it with Tesla if it seems excessive.
Estimated repair cost
Dealer / service center
— – —
Excessive degradation may be covered under the battery warranty (which includes a capacity-retention guarantee); get an evaluation from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w028_sw_drive_iso_stddevBattery Management System — Unstable High-Voltage Isolation Readings
- bms_w126_hw_bms_blind_mateBattery Management System — High-Voltage Connector Not Fully Seated (Blind-Mate Detection)
- bms_a037_sw_flood_port_openBattery Management System — Flood Port Detected Open
- bms_a136_sw_module_ot_warningBattery Management System — Module Overtemperature Warning