All codes

esp_a059_relwssnopulsesdetected

Drive with caution

Tesla · ESP system

Stability Control (ESP) — Rear Left Wheel Speed Sensor Not Reading

What it means

The stability control system is getting no pulse signal from the rear-left wheel speed sensor. Without that wheel's speed data, the car disables stability control and traction control and dials back ABS performance, because it can no longer tell what that wheel is doing.

Symptoms

  • "ABS disabled — Drive cautiously" message
  • Stability control and traction control turned off
  • Longer stopping distances possible under hard braking
  • Warning chime when the fault sets

Likely causes (by probability)

  1. 1.Failed rear-left wheel speed sensorHigh
  2. 2.Damaged sensor wiring or corroded connector (road salt, debris)Medium
  3. 3.Debris or damage on the sensor tone ring/encoderLow

What you can check yourself

  • 01Inspect the rear-left wheel area for obvious wiring damage or debris — a safe, driveway-level check
  • 02Drive gently: no stability control means easier wheelspin and slides in the wet
  • 03A sensor or harness replacement on this corner is one of the more DIY-friendly Tesla repairs if you are experienced
  • 04Clear codes after repair and confirm ABS/stability warnings stay off on a short test drive

EV systems involved in esp_a059_relwssnopulsesdetected

Braking & stability control

Friction brakes blended with regenerative braking, ABS/stability electronics, and wheel-speed sensors. Because regen does most slowing in an EV, brake hardware sees less wear — but its sensors and software are still safety-critical.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Deep dive: what owners should know

The wheel-speed sensors are the unsung foundation of the modern car's safety stack. ABS, traction control, stability control, and — in an EV — the blending of regenerative and friction braking all begin with knowing precisely how fast each wheel is turning. ESP_A059 reports that the rear-left sensor has gone silent: the stability controller commands the data, and no pulses come back. The downstream effects cascade in a predictable order. With one wheel's speed unknown, the stability system loses confidence in its core model and withdraws: ABS and traction control disable first, then stability interventions, and the dash lights the corresponding warning lamps to tell you the safety net is currently folded. Regenerative braking behavior may change as the car falls back to conservative blending, because regen distribution calculations also lean on wheel-speed data. The driver notices little in gentle driving — the car brakes and handles normally — which is exactly why the warning lamps exist, because the degraded state only reveals itself in the emergency the systems were built for. The causes stratify cheap-to-expensive with satisfying neatness. The sensor itself is a small, inexpensive component mounted at the hub, and its failure — or its signal corruption from a damaged cable in the wheel-well's flex zone — accounts for the majority of cases. The tone ring it reads, a toothed wheel on the hub or axle, can crack or shift and present the same silence. Wiring upstream of both is the rarer third cause. A competent diagnosis distinguishes sensor from ring from harness in under an hour, and sensor replacement is among the cheapest safety-system repairs in the industry — the one happy ending this category of codes reliably offers. Until it is fixed, treat the warning lamps as literal: your safety systems are offline, and the margin you have been counting on is thinner than usual.

Severity

Drive with caution

The car still brakes, but without ABS, traction, or stability help on that corner. Drive conservatively — especially in rain or snow — until the sensor is fixed.

Estimated repair cost

Dealer / service center

— – —

Usually a wheel speed sensor or harness repair — a relatively inexpensive fix; varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site