gtw_w158_opcrel1versionmismatch
Drive with cautionTesla · GTW system
Gateway — Rear-Left Oil Pump Controller Firmware Mismatch
What it means
The gateway detected that the rear-left oil pump controller (part of the drive-unit cooling/lubrication system on Plaid models) is running firmware that does not match the rest of the car. This usually follows a partial software update. The catch: without that pump's waste-heat function, cold-weather charging can be slower or limited.
Symptoms
- "Incompatible drive system software detected" message
- "OK to drive — schedule service to update software" instruction
- Slower DC fast charging in cold weather
- Battery may not precondition using drive-unit waste heat
Likely causes (by probability)
- 1.Incomplete software update that skipped the pump controllerHigh
- 2.Failed firmware flash on that controllerMedium
- 3.Controller replacement without a firmware redeployLow
What you can check yourself
- 01Connect to Wi-Fi and let the pending software update complete
- 02In cold weather, plan for slower fast charging until this is resolved
- 03Use navigation-to-charger so the car preconditions the battery as best it can
- 04If the alert survives a full successful update, schedule service
EV systems involved in gtw_w158_opcrel1versionmismatch
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Fine to drive. The main real-world impact is slower cold-weather charging — run the software update and it should sort itself out.
Estimated repair cost
Dealer / service center
— – —
Typically a software redeploy at little or no cost; varies by warranty status — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- gtw_w017_bmsversionmismatchGateway — Incompatible BMS Firmware, Car Blocks Driving and Charging
- gtw_w406_bussleepfailureGateway — CAN Bus Will Not Go to Sleep
- gtw_w012_bmsversionmismatchGateway — Battery Firmware Version Mismatch
- bms_w039_sw_dc_link_over_voltageBattery Management System — Over-Voltage on the High-Voltage Bus (Outside the Pack)