All guides

Tesla Jack Pads Buying Guide (Jack Pucks / Lift Pads)

7 min read

The battery pack is your Tesla's floor — jack in the wrong spot and you could be shopping for a five-figure battery repair. Here is which jack pads (aka jack pucks or lift pads) to buy, what they should cost, and how to use them safely.

01Why Teslas Need Jack Pads

Under a Tesla's floor sits the high-voltage battery pack — the single most expensive component in the car. The only safe places to lift are four small reinforced lift points along the rocker panels, each sized for a puck-shaped adapter.

A bare floor-jack saddle or a misplaced jack stand can dent the battery case or puncture the pack. Battery pack replacement runs well into five figures, and "owner jacked it wrong" is not a warranty claim. A set of jack pads costs $15–40. The math is not subtle.

This applies to every Model 3, Y, S and X — and any tire shop you visit should be using them too. Many owners bring their own set to the tire shop rather than trust the lift lottery.

02Rubber vs Aluminum Jack Pads

  • Rubber / polyurethane pads: $15–25 for a 4-pack. Cheap, grippy, and kind to the pinch welds. The tradeoff: they compress over time and can crack if left installed outdoors in heat or cold.
  • Aluminum pads with rubber O-ring: $25–40 for a 4-pack. More durable, a tighter fit in the lift point, and they will not deform. The pick if you rotate tires often or leave them in the frunk permanently.
  • Magnetic or screw-in variants exist; fitment quality varies by brand. Whatever you buy, it must seat fully into the lift point socket — a loose pad is worse than none.

034-Pack vs Single Pad

A single pad works if you only ever lift one corner at a time with a floor jack. A 4-pack is the practical choice: it covers jack-stand work (front and rear points on one side), tire rotations, and any shop visit where four points go on a lift at once. Most owners land on the 4-pack and keep it in the frunk.

04What They Should Cost

  • Budget rubber 4-pack: $15–20 — fine for occasional use.
  • Mid-range rubber or basic aluminum 4-pack: $20–30 — the sweet spot for most owners.
  • Premium aluminum 4-pack with storage case: $30–40 — worth it if you DIY regularly.
  • Anything above ~$40 for a 4-pack is branding, not engineering.

05Where to Buy

Amazon carries the widest selection of Tesla jack pads, jack pucks and lift pads from multiple brands — check reviews for your specific model year, since lift-point sockets differ slightly between generations.

As an Amazon Associate we earn from qualifying purchases — it does not cost you anything extra.

06Using Them Safely

  • Park on flat, solid ground; set Park and chock the opposite wheels.
  • The four lift points sit just behind the front wheels and just ahead of the rear wheels, marked by small notches in the rocker panel.
  • Press each pad fully into the lift-point socket before the jack saddle touches it.
  • Lift slowly, then support with jack stands before any part of you goes under the car — a jack alone is never enough.
  • Torque lug nuts to spec when the wheels go back on: 129 lb-ft (175 Nm) on Model 3/Y.
  • Never work near orange high-voltage cabling, and never place a jack or stand under the battery pack itself.

07Related Repairs

Jack pads come up most often in two jobs: tire rotations and replacements, and suspension work like control arms. Both pages below include cost ranges and DIY difficulty ratings.

08Disclaimer

Lifting a vehicle carries real risk. Follow your owner's manual and the jack manufacturer's instructions, and if anything about the lift points looks damaged or corroded, stop and use a professional shop. Product links on this page may earn us a commission at no extra cost to you.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

Featured on NewTool.site