bms_a039_sw_dc_link_over_voltage
Do not driveTesla · BMS system
Battery Management System — DC Bus Overvoltage Event
What it means
The BMS detected the main high-voltage bus (the DC link feeding the drive units) climbing above its maximum threshold. That is a serious electrical event, and the car's response is to cut high-voltage power — no driving, no charging, no low-voltage support — to protect the pack and power electronics.
Symptoms
- "Unable to drive — Pull over safely" warning
- Sudden loss of drive power, possibly mid-drive
- Charging disabled
- Single chime with a battery-cutoff warning
Likely causes (by probability)
- 1.Voltage sensing fault between the BMS and the high-voltage processorMedium
- 2.Charging or regen event that spiked bus voltage beyond limitsMedium
- 3.Failing high-voltage hardware (contactors, PCS, or pack)Medium
- 4.Software or calibration error in overvoltage detectionLow
What you can check yourself
- 01Pull over safely and stay out of the frunk/underbody high-voltage areas.
- 02Note whether it happened while charging, during hard regen, or at startup — that context steers diagnosis.
- 03Do not attempt any high-voltage measurements yourself; even "simple" checks here are dangerous.
- 04Capture any companion alerts — overvoltage rarely travels alone.
EV systems involved in bms_a039_sw_dc_link_over_voltage
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Have the car towed to Tesla Service. A DC-bus overvoltage is a protective shutdown you should not try to drive through.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f141_sw_12v_pwr_supply_lowBattery Management System: 12V Power Supply Low
- bms_u029_dsoc_limitingBattery Management System — Maximum Charge Limited (Suspected Weak or Shorted Cell Group)
- bms_w073_sw_unexpctd_hv_sys_bhvrBattery Management System — Abnormal High-Voltage Bus Behavior During Precharge
- bms_w177_openvshdetectedBattery Management System — Open Circuit in the Voltage Sense Harness