All codes

bms_w073_sw_unexpctd_hv_sys_bhvr

Do not drive

Tesla · BMS system

Battery Management System — Abnormal High-Voltage Bus Behavior During Precharge

What it means

During precharge — the controlled power-up of the high-voltage system — the BMS saw the bus voltage behave in a way it shouldn't. That can mean a short, an unexpected load, or a component on the bus misbehaving. The startup sequence aborts, so the car won't start, drive, or charge.

Symptoms

  • Car won't start
  • Unable to charge
  • "Service needed" warning
  • May be intermittent — works sometimes, fails other times

Likely causes (by probability)

  1. 1.A short or partial short on the high-voltage bus (inverter, charger, heater, compressor, DC-DC)Medium
  2. 2.A failing component on the bus drawing current abnormally during power-upMedium
  3. 3.Precharge circuit fault (resistor/contactor)Medium
  4. 4.Faulty bus voltage sensingLow

What you can check yourself

  • 01Note whether the failure is consistent or intermittent, and anything that changed recently (service, updates, impacts).
  • 02Try one clean power-cycle after a 10-minute wait.
  • 03Photograph all alerts for service.
  • 04Bus-level faults require isolation of individual high-voltage components — strictly Tesla Service work.

EV systems involved in bms_w073_sw_unexpctd_hv_sys_bhvr

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Do not drive

Something on the high-voltage bus is misbehaving and the car refuses to energize it. Tow to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery or drive-unit warranty in many cases depending on the failed component; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site