All codes

bms_a051_sw_hvc_vref_bad

Safe to drive

Tesla · BMS system

Battery Management System — High-Voltage Controller Reference Voltage Off

What it means

The BMS cross-checks its voltage readings against an internal reference, and the reference coming from the high-voltage controller is out of bounds. When the measuring stick itself is bent, the car cannot fully trust its own voltage data — which can trigger other, possibly false, high-voltage alerts.

Symptoms

  • No direct symptoms in most cases
  • Silent center-display alert without a chime
  • Possible cascade of other voltage-related BMS alerts
  • Charging or driving behavior usually unchanged

Likely causes (by probability)

  1. 1.Failing reference-voltage circuit on the high-voltage controller boardMedium
  2. 2.Connector or wiring issue between the BMS and high-voltage processorMedium
  3. 3.Moisture or corrosion in the high-voltage controllerLow
  4. 4.Software/calibration mismatch after an updateLow

What you can check yourself

  • 01Watch for companion voltage-sensing alerts; the pattern helps service isolate the bad circuit.
  • 02Check whether the alert survives a full vehicle sleep cycle (park, lock, wait 10+ minutes).
  • 03Note any recent water exposure or high-voltage service work.
  • 04No DIY electrical probing here — the measurement circuits live inside high-voltage hardware.

EV systems involved in bms_a051_sw_hvc_vref_bad

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

Not urgent on its own, but have it checked at your next service — unreliable voltage references can mask or mimic real battery problems.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site