bms_a167_sw_fc_partial_weld
Drive with cautionTesla · BMS system
Battery Management System — One Fast-Charge Contactor Welded
What it means
One of the two contactors in the DC fast-charge path has welded shut. The fast-charge contactors connect the pack to the charge port during Supercharging; with one fused, the car cannot safely manage that path. The car typically still drives and AC-charges, but DC fast charging is compromised and the charge port door must be closed to drive.
Symptoms
- "Unable to charge" message related to fast charging
- DC fast charging unavailable or terminating
- Charge port door must be closed before the car will drive
- AC charging usually still works
Likely causes (by probability)
- 1.Fast-charge contactor contacts fused by a fault current during a DC sessionMedium
- 2.Contactor end-of-life from many fast-charge cyclesMedium
- 3.Faulty weld-detection circuitLow
What you can check yourself
- 01Verify AC charging works so you can keep the car fueled while waiting for service.
- 02Close the charge port door fully if the car refuses to drive — that interlock is part of this alert.
- 03Do not attempt to access the fast-charge contactors; they are high-voltage components.
- 04Note which stations and sessions preceded the alert for the technician.
EV systems involved in bms_a167_sw_fc_partial_weld
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
You can drive and AC-charge, but DC fast charging is out until the contactor is replaced. Book service before you depend on a road trip.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w018_sw_brick_uvBattery Management System — Cell Group Voltage Too Low
- bms_w103_hw_bmb_memory_parityBattery Management System — Battery Monitoring Board Memory Error
- bms_a003_sw_pack_birth_date_missingBattery Management System — Pack Manufacturing Date Unreadable
- bms_a107_sw_stack_voltage_miaBattery Management System — Stack Voltage Measurement Lost