All codes

bms_a075_sw_chg_disable_failure

Safe to drive

Tesla · BMS system

Battery Management System — Unable to Stop Charging Session

What it means

The BMS tried to end a charging session but something prevented it from disabling the charge. This is mainly a logging flag for service — it tells technicians the charge-stop path did not behave. Left unresolved, a car that cannot reliably stop charging is a control problem worth fixing.

Symptoms

  • Usually no driver-visible symptoms
  • Silent center-display alert
  • Charge session may have ended later than commanded or required unplugging to stop
  • Found mostly in service-mode alert logs

Likely causes (by probability)

  1. 1.Charge control communication glitch between the BMS and charger hardwareMedium
  2. 2.Contactor or charge-enable circuit slow to respondMedium
  3. 3.External charging equipment not honoring the stop requestLow
  4. 4.Software bug in the charge session state machineLow

What you can check yourself

  • 01Note which charger and what type (home AC, public Level 2, Supercharger) was in use when it happened.
  • 02Check whether charging stops normally on your next few sessions — a one-off is usually a glitch.
  • 03Keep software up to date; charge-control fixes ship regularly.
  • 04If charging ever refuses to stop, use the in-car "Stop Charging" button or the charge-handle release rather than forcing the cable.

EV systems involved in bms_a075_sw_chg_disable_failure

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Safe to drive

Informational. If sessions keep misbehaving or charging will not stop cleanly, mention it at your next service visit.

Estimated repair cost

Dealer / service center

— – —

Typically a no-charge software/diagnostic item; covered under battery warranty in many cases if hardware is involved.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site