bms_u004_charge_cable_connected
Drive with cautionTesla · BMS system
Battery Management System: Charge Cable Still Connected
What it means
You tried to shift into Drive while the charge cable is still plugged in. The car refuses — driving off with the cable attached would damage the charge port, the cable, and possibly the wall equipment. Unplug and you are good to go.
Symptoms
- "Unable to drive / Close charge port door" message
- Car will not shift into Drive
- Charge cable visibly connected
Likely causes (by probability)
- 1.Charge cable simply still plugged inHigh
- 2.Charge port latch stuck, keeping the car thinking a cable is attachedLow
- 3.Charge port proximity sensor faultLow
What you can check yourself
- 01Unplug the charge cable, close the charge port door firmly, and shift into Drive again
- 02If the cable will not release, use the manual release or the app — never yank it
- 03If the message persists with nothing plugged in, check the port for debris or ice around the latch
- 04A persistent false "cable connected" reading with an empty port needs a service look at the latch sensor
EV systems involved in bms_u004_charge_cable_connected
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Unplug the cable and close the port door — the car drives immediately after. Only book service if the message stays on with an empty port.
Estimated repair cost
Dealer / service center
— – —
Normally free (just unplug); a stuck latch or sensor repair is a minor-cost item — get a quote from Tesla Service if needed.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w163_sw_contactor_wot_countBattery Management System — Contactor Stress From Full-Throttle Events (Counter)
- bms_a078_rapid_dch_while_chargingBattery Management System — High Discharge Current During DC Charging
- bms_a165_sw_pack_partial_weldBattery Management System — One Pack Contactor Welded
- bms_f051_sw_current_sensor_miaBattery Management System: Current Sensor Missing (MIA)