bms_a083_sw_ctr_close_failure
Do not driveTesla · BMS system
Battery Management System — Contactor Failed to Close
What it means
The BMS commanded the pack contactors to close — connecting the battery so the car can drive or charge — but they did not complete the action. Without closed contactors, high voltage stays locked inside the pack and the car is dead in the water. Unlike the "blocked" alerts, this one points at the contactor hardware or its control path itself.
Symptoms
- Car will not go into Drive or start charging
- Clicking or unusual sounds from the pack area at startup
- Silent alert on the center display
- Problem may be intermittent at first, then permanent
Likely causes (by probability)
- 1.Worn or failing pack contactors (pitted contacts, weak coil)Medium
- 2.Contactor control/driver circuit fault in the BMS or HVPMedium
- 3.Pre-charge circuit failure preventing safe closureMedium
- 4.Low-voltage supply too weak to actuate the contactorsLow
What you can check yourself
- 01Check low-voltage battery health — a weak 12V/16V can fail to pull contactors in.
- 02Try one full sleep cycle; note whether the car ever starts successfully (intermittency is a clue).
- 03Listen at startup: repeated clicking without the car coming ready suggests contactor trouble.
- 04Do not attempt contactor replacement yourself — it requires pack-level high-voltage access.
EV systems involved in bms_a083_sw_ctr_close_failure
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
If the car will not come ready after a full sleep cycle, arrange a tow to Tesla Service — contactor work is not a driveway job.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w071_sw_sm_transcon_not_metBattery Management System — BMS Blocked From Changing State
- bms_w172_sw_drive_iso_warningBattery Management System — Repeated Low Isolation While Driving
- bms_a089_sw_vcfront_miaBattery Management System — Front Vehicle Controller Not Responding
- bms_a172_sw_isolation_failure_in_drive_warningBattery Management System — Repeated Isolation Faults While Driving