bms_w071_sw_sm_transcon_not_met
Do not driveTesla · BMS system
Battery Management System — BMS Blocked From Changing State
What it means
The BMS runs a state machine — sleep, standby, ready-to-drive, charging, and so on — and it just couldn't move into the state the car requested because a blocking condition was present. The result: the car won't start, drive, or charge. This alert is usually the visible tip of another underlying fault.
Symptoms
- Car won't start
- Unable to charge
- "Service needed" warning
- Almost always accompanied by a more specific BMS alert
Likely causes (by probability)
- 1.Another active fault (isolation, contactor, sensor) blocking the state transitionHigh
- 2.Low 12V supply preventing normal power-up sequencingMedium
- 3.BMS software/firmware glitchLow
What you can check yourself
- 01Find the companion alerts — this code is a symptom, the real cause is usually listed beside it.
- 02Verify 12V battery health and try one clean power-cycle.
- 03Check for pending vehicle software updates.
- 04If it won't clear, tow to Tesla Service with the full alert list photographed.
EV systems involved in bms_w071_sw_sm_transcon_not_met
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
The car is stuck in a safe state because something else is wrong. Identify the companion fault and get it to service.
Estimated repair cost
Dealer / service center
— – —
Cost depends on the underlying fault; battery-warranty coverage applies in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a017_sw_brick_ovBattery Management System — Cell Group Overvoltage
- bms_a122_sw_bms_therm_irrationalBattery Management System — Implausible Temperature Reading
- bms_f011_hw_illegal_ctr_reqBattery Management System: Illegal Contactor Request
- bms_f094_sw_drive_inverter_miaBattery Management System: Drive Inverter Not Responding (MIA)