All codes

bms_a086_sw_fc_contactor_mismatch

Do not drive

Tesla · BMS system

Battery Management System — Fast-Charge Contactor State Mismatch

What it means

The BMS told the fast-charge contactor to stay closed during DC charging, but feedback shows the contactor actually opened. Commanded state and real state disagree, so the DC charging session is terminated on the spot. AC charging and normal driving may be unaffected.

Symptoms

  • DC fast charging session ends abruptly
  • Supercharging fails or refuses to start
  • AC (home/Level 2) charging usually still works
  • Silent center-display alert

Likely causes (by probability)

  1. 1.Failing fast-charge contactor dropping out under loadMedium
  2. 2.Contactor feedback/sense circuit faultMedium
  3. 3.Wiring issue between the high-voltage processor and the fast-charge contactorMedium
  4. 4.Charging-station power glitch triggering the drop-outLow

What you can check yourself

  • 01Retry at a different Supercharger stall or station — rule out the station first.
  • 02Confirm AC charging still works so you are not stranded.
  • 03If the alert repeats at multiple stations, the contactor circuit needs service.
  • 04Do not attempt any work on the fast-charge contactor; it is inside the high-voltage system.

EV systems involved in bms_a086_sw_fc_contactor_mismatch

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Do not drive

DC fast charging is out of action until fixed. Fall back on AC charging and book service before your next road trip.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site