bms_u003_insufficient_drive_pwr
Do not driveTesla · BMS system
Battery Management System: Insufficient Power to Drive
What it means
The high-voltage battery's state of charge has fallen below the minimum the car needs to drive at all. This is past the normal "low battery" warnings — the pack can no longer deliver driving power and the car will not move until it gets charged.
Symptoms
- "Unable to drive / Battery charge too low" message
- Car will not shift into Drive
- Arrives at the very bottom of the usable charge range
Likely causes (by probability)
- 1.Battery simply run to emptyHigh
- 2.Vampire drain while parked unplugged for a long periodMedium
- 3.State-of-charge misestimation (actual charge higher than displayed)Low
What you can check yourself
- 01Get the car to a charger immediately — even a standard 120V outlet starts recovery
- 02If the car is stranded, use the Tesla app to arrange a tow to the nearest charger
- 03After charging resumes, let it charge on AC for several hours to stabilize the pack
- 04Watch for brick undervoltage alerts (bms_f018, bms_f146) afterward — deep discharge can leave damage
EV systems involved in bms_u003_insufficient_drive_pwr
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
The car will not drive until charged. Charge now, and if the pack refuses to accept charge, contact Tesla Service — deep discharge can become permanent damage.
Estimated repair cost
Dealer / service center
— – —
No cost if it charges normally; deep-discharge recovery or damage assessment is often not warranty-covered — get a quote from Tesla Service if charging fails.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f056_sw_module_temp_outlierBattery Management System: Module Temperature Outlier
- bms_f151_sw_external_isolationBattery Management System: External Isolation Fault
- bms_w003_hw_module_alarmBattery Management System — Battery Module Hardware Alarm
- bms_w094_sw_drive_inverter_miaBattery Management System — Drive Inverter Not Responding (Power Reduced)