bms_a127_sw_shunt_sna
Do not driveTesla · BMS system
Battery Management System — Current Sensor (Shunt) Signal Lost
What it means
The BMS is no longer receiving current readings from the shunt — the precision sensor that measures how much electricity flows in and out of the pack. Without current data the BMS cannot do its math, so the car blocks driving, charging, and low-voltage support until readings resume.
Symptoms
- "Vehicle may not restart — Service required" message
- Car may refuse to drive or charge
- State of charge and range estimates may freeze or behave oddly beforehand
- Warning icon on the cluster
Likely causes (by probability)
- 1.Communication fault between the high-voltage processor (where the shunt lives) and the BMSMedium
- 2.Failed shunt or current-sensing circuitMedium
- 3.Connector/wiring issue in the sensing pathMedium
- 4.High-voltage processor crashLow
What you can check yourself
- 01Try a full sleep cycle — a hung high-voltage processor sometimes restores the data feed.
- 02Check for companion high-voltage communication alerts.
- 03Do not attempt to measure pack current yourself; the shunt is inside the high-voltage enclosure.
- 04Note any odd state-of-charge behavior in the days before the alert.
EV systems involved in bms_a127_sw_shunt_sna
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
If readings do not return after a full sleep cycle, arrange service or a tow — the car stays disabled without current data.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w023_sw_contactors_open_hwocBattery Management System — Contactors Opened by Over-Current Events (Counter)
- bms_w104_hw_bmb_enumerationBattery Management System — Battery Monitoring Board Failed Startup Enumeration
- bms_a007_sw_slowed_chg_batt_coldBattery Management System — Charging Slowed, Battery Cold
- bms_a109_hw_bmb_mute_status_mismatchBattery Management System — Cell Monitor Mute State Mismatch