All codes

bms_a109_hw_bmb_mute_status_mismatch

Safe to drive

Tesla · BMS system

Battery Management System — Cell Monitor Mute State Mismatch

What it means

During cell balancing, the BMS tells the monitoring boards to "mute" certain measurement channels so balancing currents do not corrupt the readings. This alert means a board's actual mute state does not match what the BMS commanded. The practical risk is slightly corrupted state-of-charge estimation, not an immediate safety issue.

Symptoms

  • No driver-visible symptoms
  • Silent center-display alert
  • State of charge estimates may drift or jump
  • Found mainly in service logs

Likely causes (by probability)

  1. 1.Monitoring board not executing mute commands correctlyMedium
  2. 2.Communication glitch on the monitoring daisy-chainMedium
  3. 3.Firmware mismatch between BMS and monitoring boardsLow

What you can check yourself

  • 01Watch for odd state-of-charge jumps (e.g., sudden drops of several percent) and report them.
  • 02Check whether the alert recurs after balancing sessions (long AC charges).
  • 03Keep software up to date — board firmware coordination is update-delivered.
  • 04No DIY involvement; this is internal pack electronics.

EV systems involved in bms_a109_hw_bmb_mute_status_mismatch

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Severity

Safe to drive

Not urgent. Mention it at your next service, especially if you also notice erratic range or state-of-charge readings.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; often resolved by software or board replacement at service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site