All codes

bms_a142_sw_isolation_degradation

Drive with caution

Tesla · BMS system

Battery Management System — Isolation Degraded (Warning Level)

What it means

With the contactors closed, the BMS measured high-voltage isolation to chassis below its warning threshold — but still above the hard minimum required to operate. Think of it as an early-warning stage of an isolation fault: the car still works, but something is starting to leak and the trend matters.

Symptoms

  • No immediate drivability change
  • Silent center-display alert
  • May appear in damp weather or after water exposure
  • Can escalate to a full isolation fault over time

Likely causes (by probability)

  1. 1.Early moisture ingress in a high-voltage component or connectorMedium
  2. 2.Aging insulation or contamination (dirt, coolant residue) on high-voltage partsMedium
  3. 3.A high-voltage accessory (compressor, heater, charge port) starting to leakMedium
  4. 4.Measurement drift in the isolation monitorLow

What you can check yourself

  • 01Note weather and recent conditions — rain, car washes, and humidity often correlate with marginal isolation.
  • 02Check whether it clears in dry conditions and returns when wet; that pattern points to moisture.
  • 03Do not probe high-voltage components to find the leak — isolation testing needs professional gear.
  • 04Schedule service before it degrades into a hard fault that strands the car.

EV systems involved in bms_a142_sw_isolation_degradation

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Drive with caution

Drivable today, but this is a trend alert — get it diagnosed while it is still a warning, not after it becomes a breakdown.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site