All codes

bms_a092_sw_chargeport_mia_on_hvs

Do not drive

Tesla · BMS system

Battery Management System — Charge Port Lost on High-Voltage System

What it means

Functionally the same family as the standard charge-port communication loss: the BMS cannot hear the charge port on the high-voltage side of the network, so charging is blocked and the broader high-voltage functions — driving and low-voltage support — may also be restricted.

Symptoms

  • Charging unavailable
  • Car may refuse to drive or come ready
  • Silent center-display alert
  • Charge port may appear dead

Likely causes (by probability)

  1. 1.Charge port controller offline or unpoweredMedium
  2. 2.CAN wiring fault on the high-voltage network segmentMedium
  3. 3.Connector corrosion or damage at the charge portMedium
  4. 4.Failed charge port hardwareLow

What you can check yourself

  • 01Try a full sleep cycle before anything else — many communication losses clear on a clean wake.
  • 02Inspect the port area visually for water or physical damage.
  • 03Check whether other high-voltage network alerts accompany it, pointing to a wider wiring issue.
  • 04Do not probe port wiring yourself.

EV systems involved in bms_a092_sw_chargeport_mia_on_hvs

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Do not drive

Charging is blocked and the car may not drive. If the alert survives a full sleep cycle, schedule service.

Estimated repair cost

Dealer / service center

— – —

Charge port repairs are often covered under the basic vehicle or battery warranty; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site