All codes

bms_a143_sw_cac_change

Safe to drive

Tesla · BMS system

Battery Management System — Large Capacity Estimate Update

What it means

The BMS significantly revised its estimate of how much energy the pack can hold (the calculated amp-hour capacity). A big adjustment is logged because sudden capacity changes can indicate a real pack change — or just the estimate finally catching up after unusual usage. Mostly informational.

Symptoms

  • Displayed full-charge range may jump noticeably up or down
  • No drivability change
  • Silent center-display alert
  • Often follows a period of unusual charging or a software update

Likely causes (by probability)

  1. 1.Capacity estimate recalibrating after atypical usage (long storage, unusual charge patterns)High
  2. 2.Real capacity loss from aging or a degrading moduleMedium
  3. 3.Software update changing the estimation modelLow

What you can check yourself

  • 01Compare your displayed 100% range against historical values (apps like Tessie or your own records) to see if the change is real.
  • 02Do a full AC charge to 100% and let it balance, then note the displayed range.
  • 03If the drop is large and sudden, ask service to run a battery health check — warranty decisions depend on measured capacity.
  • 04Track the trend over months, not days.

EV systems involved in bms_a143_sw_cac_change

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

No immediate action. If the new capacity number is dramatically lower, request a battery health report at your next service visit.

Estimated repair cost

Dealer / service center

— – —

Battery health checks are typically free at service; capacity loss beyond warranty thresholds may qualify for coverage.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site