All codes

bms_a094_sw_drive_inverter_mia

Drive with caution

Tesla · BMS system

Battery Management System — Drive Inverter Communication Lost

What it means

The BMS has lost CAN communication with one of the drive inverters — the power electronics that turn battery DC into motor AC. Without that link, the BMS limits power to protect the system, so the car drives with noticeably reduced performance.

Symptoms

  • Reduced power / limited acceleration
  • Silent center-display alert
  • Possible "power limited" turtle-style behavior
  • Dual-motor cars may feel like driving on one motor

Likely causes (by probability)

  1. 1.Drive inverter crashed or rebootingMedium
  2. 2.CAN wiring/connector fault to the inverterMedium
  3. 3.Low-voltage supply glitch at the inverterMedium
  4. 4.Failing inverter hardwareLow

What you can check yourself

  • 01Pull over, do a full sleep cycle, and check whether full power returns.
  • 02Note whether the power loss was sudden or gradual, and any sounds from the drive unit.
  • 03Check for companion drive-unit alerts that identify which motor/inverter dropped out.
  • 04Keep software current; inverter communication bugs are sometimes firmware.

EV systems involved in bms_a094_sw_drive_inverter_mia

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Drive gently to service if power stays limited — avoid highways and passing situations until the inverter link is restored.

Estimated repair cost

Dealer / service center

— – —

Drive unit and inverter issues are typically covered under the drive unit warranty; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site