bms_a179_hvpgporequestactive
Do not driveTesla · BMS system
Battery Management System — High-Voltage Processor Requested Shutdown
What it means
The high-voltage processor (HVP) has asked the BMS to perform a graceful power-off of the high-voltage system. The HVP makes that call when it sees something serious on its side — contactor, current, or switching faults. While the request is active, driving, charging, and low-voltage support are blocked.
Symptoms
- "Vehicle may not restart — Service required" message
- Car cannot drive or charge
- Single chime with a warning icon
- Companion HVP or contactor alerts usually present
Likely causes (by probability)
- 1.HVP detected a contactor, current-sensing, or switching fault and requested shutdownHigh
- 2.HVP hardware faultMedium
- 3.Communication desync between HVP and BMSLow
What you can check yourself
- 01Look for the companion HVP-side alerts — they carry the actual reason.
- 02Try one full sleep cycle; if the request reasserts, stop troubleshooting.
- 03Do not attempt any high-voltage work; the fault is in the pack/contactor domain.
- 04Arrange service or a tow if the car stays disabled.
EV systems involved in bms_a179_hvpgporequestactive
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
The car is down by request of its own high-voltage controller. Companion alerts will guide the fix — get it to service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w172_sw_drive_iso_warningBattery Management System — Repeated Low Isolation While Driving
- bms_a089_sw_vcfront_miaBattery Management System — Front Vehicle Controller Not Responding
- bms_a172_sw_isolation_failure_in_drive_warningBattery Management System — Repeated Isolation Faults While Driving
- bms_f063_sw_precharge_failureBattery Management System: Precharge Failure