All codes

bms_f063_sw_precharge_failure

Do not drive

Tesla · BMS system

Battery Management System: Precharge Failure

What it means

Before connecting the pack, the car "precharges" the high-voltage bus through a resistor to avoid a massive inrush current. This alert means precharge did not complete as expected, so the main contactors were never allowed to close. The exact blocking detail is stored in the alert log data.

Symptoms

  • "Unable to start vehicle / Service required" message
  • Car powers on but never engages high-voltage systems
  • Repeated failed start attempts may trigger the precharge-resistor-hot alert too

Likely causes (by probability)

  1. 1.Failed precharge resistor or precharge contactorMedium
  2. 2.External short or heavy load on the high-voltage bus (inverter, charger, DC-DC fault)Medium
  3. 3.Precharge voltage sensing faultLow

What you can check yourself

  • 01Limit restart attempts — each failed precharge heats the resistor (see bms_f031)
  • 02Check for companion alerts like bms_f149 (precharge too short), bms_f073 (abnormal bus behavior), or bms_f086
  • 03Do one full power-down, wait 30 minutes, and try a single restart
  • 04Everything involved is pack-internal high voltage — no DIY diagnosis beyond logging conditions

EV systems involved in bms_f063_sw_precharge_failure

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Not drivable. One restart attempt after a cool-down is acceptable; if it fails, tow to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site