All codes

bms_f027_sw_drive_iso_repeated

Do not drive

Tesla · BMS system

Battery Management System: Repeated Isolation Loss While Driving

What it means

High-voltage isolation is the electrical barrier between the battery pack and the car body. The BMS measured isolation dropping below the safe minimum multiple times while driving, which can indicate moisture ingress, damaged insulation, or a failing high-voltage component. After repeated events the car refuses to start until the counter is manually reset by service.

Symptoms

  • "Unable to start vehicle / Service required" message
  • Car will not restart after being parked
  • May follow driving through deep water, heavy rain, or high humidity conditions

Likely causes (by probability)

  1. 1.Moisture or water ingress into a high-voltage component (junction box, charge port, heater, compressor)High
  2. 2.Damaged high-voltage cable insulation or chafed wiringMedium
  3. 3.Failing high-voltage accessory (PTC heater, A/C compressor, onboard charger)Medium
  4. 4.Isolation monitoring circuit fault giving false low readingsLow

What you can check yourself

  • 01Note whether the alert followed rain, car washes, or water exposure — this is the single most useful clue
  • 02Do NOT probe or disconnect any orange high-voltage cabling yourself
  • 03Check for companion isolation alerts (bms_f123, bms_f151, bms_f158) to show the pattern
  • 04If the car still drives, drive it only to a safe parking spot and schedule service — isolation faults can escalate

EV systems involved in bms_f027_sw_drive_iso_repeated

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Repeated isolation loss is a shock-safety issue, not a performance issue. Do not drive — have the car inspected by Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Cost depends heavily on which component is leaking isolation; pack-internal issues are covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site