All codes

bms_w052_sw_charger_mia

Drive with caution

Tesla · BMS system

Battery Management System — Onboard Charger Not Responding

What it means

The BMS has lost CAN communication with the car's main onboard charger — the hardware that converts AC from your wall or Level 2 station into DC for the battery. With the charger offline, the car can't charge, though driving is typically unaffected until the battery runs down.

Symptoms

  • Car won't charge (AC charging fails)
  • Charging-related warnings on screen
  • Car still drives normally while it has charge
  • May be intermittent at first

Likely causes (by probability)

  1. 1.Failed onboard chargerMedium
  2. 2.CAN wiring or connector fault between the BMS and chargerMedium
  3. 3.Blown fuse or lost power supply to the chargerMedium
  4. 4.Software glitch cleared by a reboot or updateLow

What you can check yourself

  • 01Reboot the car and retry charging once with a known-good AC station or your home connector.
  • 02Check for pending software updates.
  • 03Note whether DC fast charging still works — that helps isolate the fault to the AC charger path.
  • 04If the charger stays offline, schedule service — conserve remaining battery until then.

EV systems involved in bms_w052_sw_charger_mia

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

You can keep driving, but you can't refill the battery. Head toward a charger while you have range and book service promptly.

Estimated repair cost

Dealer / service center

— – —

Onboard charger replacement is often covered under the battery/vehicle warranty; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site