bms_f030_sw_chg_port_door_open
Do not driveTesla · BMS system
Battery Management System: Charge Port Door Open with Welded Fast-Charge Contactor
What it means
The BMS detected two things at once: the charge port door is open, and the fast-charge contactor appears to be welded (stuck closed). Because a welded contactor could leave high voltage present at the charge port, the car refuses to drive as a safety interlock. Sometimes the door simply is not closed fully; the welded-contactor detection is what makes this serious.
Symptoms
- "Unable to drive / Close charge port door" message
- Car will not shift into Drive
- Charge port door visibly open or not fully latched
Likely causes (by probability)
- 1.Charge port door not fully closed or door sensor faultHigh
- 2.Fast-charge contactor genuinely welded inside the packMedium
- 3.False welded-contactor detection from a sensing faultLow
What you can check yourself
- 01Close the charge port door firmly and check the seal — ice, dirt, or a stuck flap can keep the sensor from registering closed
- 02Power-cycle the car (full exit, lock, wait 5 minutes) after closing the door and retry
- 03If the message persists with the door confirmed closed, do not force anything — a welded contactor is pack-internal hardware
- 04Never insert tools or fingers into the charge port to manipulate it
EV systems involved in bms_f030_sw_chg_port_door_open
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
First make sure the charge port door is genuinely closed — that alone often clears it. If the message stays, the fast-charge contactor may be welded: do not drive, call Tesla Service.
Estimated repair cost
Dealer / service center
— – —
Door/sensor fixes are minor; a welded contactor is pack-internal and covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w142_sw_isolation_degradatioBattery Management System — High-Voltage Isolation Degraded (Warning Level)
- bms_a056_sw_standby_supply_faultBattery Management System — Standby Power Supply Fault
- bms_a148_sw_unsupported_bmb_asic_typeBattery Management System — Unsupported Cell Monitor Chip Type
- bms_f124_sw_bmb_comm_integrityBattery Management System: Battery Monitoring Board Communication Integrity Issue