All codes

bms_w142_sw_isolation_degradatio

Drive with caution

Tesla · BMS system

Battery Management System — High-Voltage Isolation Degraded (Warning Level)

What it means

With the pack connected, the BMS measured high-voltage isolation below its warning threshold — weaker than it should be, but still above the minimum needed to operate safely. It's an early heads-up that insulation somewhere in the high-voltage system is degrading, often from moisture or an aging component.

Symptoms

  • Usually no drivability change — warning-level alert
  • May appear or worsen in wet/humid weather
  • Can precede harder isolation shutdowns if it progresses

Likely causes (by probability)

  1. 1.Moisture or condensation in a high-voltage component or connectorHigh
  2. 2.Early insulation breakdown in a component (heater, compressor, drive unit, pack)Medium
  3. 3.Contamination or corrosion on high-voltage connectionsMedium

What you can check yourself

  • 01Log when it appears — wet-weather correlation points at moisture ingress.
  • 02Scan for related isolation alerts with Scan My Tesla and track the trend.
  • 03Schedule a service evaluation before it degrades into a no-drive isolation fault.
  • 04Never probe high-voltage components yourself — isolation faults are exactly what protects you from shock.

EV systems involved in bms_w142_sw_isolation_degradatio

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Drive with caution

Drivable for now, but this is insulation slowly losing the fight. Get it diagnosed before it becomes a shutdown-level fault.

Estimated repair cost

Dealer / service center

— – —

Early diagnosis is far cheaper than a post-failure repair; battery-warranty coverage applies in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site