All codes

bms_f031_sw_precharge_res_hot

Do not drive

Tesla · BMS system

Battery Management System: Precharge Resistor Overtemperature

What it means

Before the main contactors close, the pack uses a precharge resistor to ramp voltage up gently. The BMS detected this resistor running hotter than its maximum — almost always because the contactors were opened and closed too many times in a short window, dumping repeated energy into the resistor. The car blocks further attempts until it cools.

Symptoms

  • "Unable to start vehicle / Service required" message
  • Car refuses to power up high-voltage systems
  • Often follows repeated start attempts or rapid key cycling

Likely causes (by probability)

  1. 1.Too many contactor close attempts in a short time (repeated start tries)High
  2. 2.Another fault causing precharge to abort and retry repeatedlyMedium
  3. 3.Failing precharge resistor or its temperature sensingLow

What you can check yourself

  • 01Stop cycling the car — let it sit parked and powered down for 30+ minutes so the resistor cools, then try once more
  • 02Look for companion precharge alerts (bms_f063, bms_f086, bms_f149) that explain why precharge kept retrying
  • 03If it will not start after cooling, do not keep retrying — each attempt reheats the resistor
  • 04Record how many start attempts were made before the alert; service will want to know

EV systems involved in bms_f031_sw_precharge_res_hot

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Give the car a long, undisturbed rest and try once. If it still will not start, have it towed — repeated attempts make things worse.

Estimated repair cost

Dealer / service center

— – —

If the resistor survived, this may cost nothing beyond diagnosis; pack-internal repairs are covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site