All codes

bms_w001_hw_over_current

Do not drive

Tesla · BMS system

Battery Management System — Hardware Over-Current (Battery Shut Down)

What it means

The BMS detected battery pack current surging past a hard hardware safety limit and opened the main contactors to protect the pack. With the contactors open, the car can't drive, can't charge, and can't support the 12V system from the big battery. This is a serious protection event, not a nuisance alert.

Symptoms

  • Sudden loss of drive — car may stop or refuse to start
  • Unable to charge the vehicle
  • "Service needed — pull over safely" warning
  • Possible accompanying alerts about contactors or power loss

Likely causes (by probability)

  1. 1.An internal short or fault in the high-voltage system drawing excessive currentHigh
  2. 2.A failing drive inverter or onboard charger pulling abnormal currentMedium
  3. 3.Damaged high-voltage cabling or connectors (collision, rodent, corrosion)Medium
  4. 4.A faulty current sensor reporting false over-currentLow

What you can check yourself

  • 01Pull over safely and do not keep trying to drive or charge — repeated attempts can worsen the damage.
  • 02Photograph all alerts on screen and note what happened just before (charging, acceleration, impact).
  • 03Check for visible collision or underbody damage that could have affected high-voltage cabling.
  • 04Arrange a tow to Tesla Service — the high-voltage system must be diagnosed by professionals; never probe it yourself.

EV systems involved in bms_w001_hw_over_current

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Treat this as a stop-driving event. Have the car towed to Tesla Service — the battery shut itself down to prevent something much worse.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site