bms_f079_sw_ctr_pwr_interrupted
Do not driveTesla · BMS system
Battery Management System: Contactor Power Interrupted
What it means
The BMS detected that the power feed to the battery contactors was interrupted, and that the pack's internal service disconnect (the manual cutoff used by technicians) may be open. Without contactor power, the pack disconnects and stays disconnected.
Symptoms
- Driving, charging, and low-voltage support disabled
- Car may have lost high-voltage power suddenly
- Often no customer text — appears in logs
Likely causes (by probability)
- 1.Service disconnect not fully seated (after recent service work)High
- 2.Contactor power supply wiring fault or blown fuseMedium
- 3.12V system failure cutting contactor feedMedium
What you can check yourself
- 01Ask whether any service work was done recently — an unseated service disconnect is the classic cause
- 02Check 12V battery health as a contributing factor
- 03Do not attempt to reseat the service disconnect yourself — it is a high-voltage safety device
- 04Check companion alerts bms_f062 (contactor power low) and bms_f141 (12V supply low)
EV systems involved in bms_f079_sw_ctr_pwr_interrupted
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Not drivable until contactor power is restored. If recent service occurred, tell Tesla exactly that — it speeds up diagnosis.
Estimated repair cost
Dealer / service center
— – —
Often a quick reseat or fuse fix after service; pack-internal issues covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a029_dsoc_limitingBattery Management System — Charge Voltage Capped (Cell Imbalance Protection)
- bms_a129_sw_vsh_failureBattery Management System — Voltage Sense Harness Fault
- bms_f018_sw_brick_uvBattery Management System: Brick Undervoltage
- bms_f103_hw_bmb_memory_parityBattery Management System: Battery Monitoring Board Memory Error