bms_a029_dsoc_limiting
Drive with cautionTesla · BMS system
Battery Management System — Charge Voltage Capped (Cell Imbalance Protection)
What it means
The BMS has detected a condition inside the pack — usually a significant state-of-charge spread between cell groups — and responded by capping the maximum cell voltage it will allow during charging, roughly equivalent to a 50% charge ceiling. It is a protective limp for the battery, triggered by an underlying imbalance alert.
Symptoms
- Charging stops well below your set limit
- Noticeably reduced usable range per charge
- No warning chime — alert sits quietly on the center display
- Another underlying cell-imbalance alert is usually present
Likely causes (by probability)
- 1.A weak cell group pulling the pack's state-of-charge spread out of specHigh
- 2.Long-term charging habits that never let the BMS balance the packMedium
- 3.Early cell failure inside one moduleMedium
What you can check yourself
- 01Check for the underlying imbalance alert (delta-SOC) — that is the root cause this alert is protecting against.
- 02Try charging on AC to the cap and letting the car sit plugged in for hours so balancing can run.
- 03Track how much energy a full session adds over several charges; a shrinking number suggests real degradation.
- 04Do not attempt pack disassembly — imbalance diagnosis needs service-level tools.
EV systems involved in bms_a029_dsoc_limiting
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
The car still works on reduced range. Schedule service to investigate the underlying imbalance before it progresses.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w001_hw_over_currentBattery Management System — Hardware Over-Current (Battery Shut Down)
- bms_w086_sw_not_ok_to_prechargeBattery Management System — Precharge Blocked (Car Won't Power Up)
- bms_f071Battery Management System — Internal BMS Hardware Fault
- bms_a094_sw_drive_inverter_miaBattery Management System — Drive Inverter Communication Lost