bms_f080_sw_int_hv_disconnect
Do not driveTesla · BMS system
Battery Management System: Internal High-Voltage Disconnect Detected
What it means
The BMS compared the total pack voltage to the sum of all brick voltages and found a gap — meaning voltage is being lost somewhere inside the pack, typically across an internal disconnect or connection point. The car refuses to charge, drive, or support the 12V system until the readings agree again.
Symptoms
- "Service required / Schedule service" message
- Car will not charge or drive
- Low-voltage system not supported by the pack
Likely causes (by probability)
- 1.Internal pack disconnect open or partially connectedHigh
- 2.High-resistance connection at an internal pack junctionMedium
- 3.Voltage sensing fault mimicking a disconnectLow
What you can check yourself
- 01Check for the companion voltage-mismatch alerts bms_f059 and bms_f110 — together they confirm a sensing vs. connection issue
- 02Try one full power-down to rule out a transient measurement glitch
- 03Note any recent pack service or repairs where an internal disconnect could have been disturbed
- 04Absolutely no DIY — this fault is inside the sealed high-voltage pack
EV systems involved in bms_f080_sw_int_hv_disconnect
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
The car is not drivable or chargeable. Arrange service; this is pack-internal hardware that only Tesla should touch.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w104_hw_bmb_enumerationBattery Management System — Battery Monitoring Board Failed Startup Enumeration
- bms_a007_sw_slowed_chg_batt_coldBattery Management System — Charging Slowed, Battery Cold
- bms_a109_hw_bmb_mute_status_mismatchBattery Management System — Cell Monitor Mute State Mismatch
- bms_f007_sw_module_alarm_brokenBattery Management System — Module Alarm Circuit Not Working