bms_f096_sw_fast_charger_mia
Drive with cautionTesla · BMS system
Battery Management System: Fast Charger Communication Lost
What it means
During a DC fast-charging session, the BMS stopped receiving the required messages from the charging station. The car cannot fast charge without that digital handshake, but AC charging at home or destination chargers still works normally.
Symptoms
- Supercharging session fails to start or drops out
- AC charging works fine
- No customer text in many cases — appears in logs
Likely causes (by probability)
- 1.Supercharger station fault or damaged cable/connector on the stallHigh
- 2.Car-side charge port communication pin problemMedium
- 3.Fast-charge contactor or comm wiring fault in the carLow
What you can check yourself
- 01Try a different stall, then a completely different Supercharger station — if it works elsewhere, the station was the problem
- 02Inspect the charge port pins (car off) for debris or damage on the communication pins
- 03Report faulty stalls in the Tesla app — it helps you and everyone else
- 04If no station works, schedule service to check the car-side fast-charge path
EV systems involved in bms_f096_sw_fast_charger_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
You can drive and AC charge normally; only DC fast charging is affected. Rule out the station before booking service.
Estimated repair cost
Dealer / service center
— – —
Free if the station was at fault; car-side repairs covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f124_sw_bmb_comm_integrityBattery Management System: Battery Monitoring Board Communication Integrity Issue
- bms_u016_feim_delayed_ctr_closeBattery Management System — Extra Isolation Check Before Powering Up
- bms_w061_sw_bms_power_supplyBattery Management System — BMS Supply Voltage Out of Range
- bms_w163_sw_contactor_wot_countBattery Management System — Contactor Stress From Full-Throttle Events (Counter)