All codes

bms_u016_feim_delayed_ctr_close

Safe to drive

Tesla · BMS system

Battery Management System — Extra Isolation Check Before Powering Up

What it means

Before closing the main battery contactors (the big relays that connect the pack to the car), the battery management system has ordered one more high-voltage isolation self-check. That simply delays the contactors closing by a short time while the car verifies everything is safe. You'll see a "please wait" style message.

Symptoms

  • Brief "please wait, system performing checks" message at startup or when plugging in
  • Short delay before the car is ready to drive or charge
  • No lasting effect once the check completes

Likely causes (by probability)

  1. 1.A routine, mandatory isolation measurement the BMS performs periodicallyHigh
  2. 2.A borderline isolation reading that triggered a confirmation re-checkMedium
  3. 3.Moisture or contamination slightly affecting high-voltage insulationLow

What you can check yourself

  • 01Just wait for the check to finish — it should clear on its own within a short time.
  • 02Note how often it happens; an occasional appearance is normal.
  • 03If it becomes frequent or is joined by isolation-related alerts, scan the car with Scan My Tesla and mention it at service.

EV systems involved in bms_u016_feim_delayed_ctr_close

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Severity

Safe to drive

This is the car double-checking its own safety systems — normal behavior. Only worth a service mention if it starts happening constantly.

Estimated repair cost

Dealer / service center

— – —

No repair expected for occasional occurrences. Frequent re-checks can indicate an isolation issue that is usually covered under the battery warranty; get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site