All codes

bms_f142_sw_isolation_degradatio

Drive with caution

Tesla · BMS system

Battery Management System: Isolation Degradation Warning

What it means

With the contactors closed, the BMS measured high-voltage isolation below a warning threshold — but still above the absolute minimum needed to operate. Think of it as a yellow light: isolation is degrading somewhere in the high-voltage system, and the car wants it looked at before it becomes a red light.

Symptoms

  • No customer-facing symptoms — warning-level log entry
  • Vehicle continues to operate normally
  • May worsen in wet or humid conditions

Likely causes (by probability)

  1. 1.Early moisture ingress in a high-voltage component (heater, compressor, charge port)High
  2. 2.Aging insulation on high-voltage cablingMedium
  3. 3.Contamination (dirt, salt, coolant) on high-voltage connectorsLow

What you can check yourself

  • 01Track whether the alert appears more often in rain or humidity — moisture-driven degradation is the usual story
  • 02Watch for escalation to harder isolation faults (bms_f123, bms_f151, bms_f027)
  • 03Mention it at your next service visit and ask for an isolation trend check
  • 04Do not probe any orange high-voltage cabling yourself

EV systems involved in bms_f142_sw_isolation_degradatio

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Drive with caution

Drivable today, but schedule a service check — isolation degradation is a trend you want caught early, especially before wet seasons.

Estimated repair cost

Dealer / service center

— – —

Early diagnosis is cheap; component replacement is covered under warranty where applicable — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site