All codes

bms_f153_sw_neg_contactor_welded

Do not drive

Tesla · BMS system

Battery Management System: Negative Contactor Welded

What it means

The mirror of the positive-side fault: the negative main contactor has welded shut and can no longer open on command. The pack loses its ability to fully disconnect from the car, so the BMS disables operation and latches the alert until service repairs and manually clears it.

Symptoms

  • Driving, charging, and low-voltage support disabled
  • High-voltage system may not power down correctly
  • Often found alongside other contactor-stress alerts

Likely causes (by probability)

  1. 1.Contacts fused by arcing during under-load opening eventsHigh
  2. 2.End-of-life contactor wear from high cycle count or stress eventsMedium
  3. 3.Weld-detection sensing faultLow

What you can check yourself

  • 01No restart cycling — this is hardware, not software
  • 02Review companion alerts (bms_f024 under-load opening, bms_f161 contactor stress) to understand what welded it
  • 03Screenshot your alert list for service — the stress history supports a warranty claim
  • 04Pack-internal, high-voltage repair — no DIY under any circumstances

EV systems involved in bms_f153_sw_neg_contactor_welded

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Not drivable. Arrange a tow — the contactor must be replaced and the alert manually cleared by Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Contactor replacement is covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site