All codes

bms_f151_sw_external_isolation

Do not drive

Tesla · BMS system

Battery Management System: External Isolation Fault

What it means

With the contactors closed, the BMS measured isolation below the safe threshold — and because the contactors were closed, the leak is somewhere outside the battery pack: in the drive inverter, onboard charger, DC-DC converter, heater, compressor, or the cabling between them.

Symptoms

  • "Unable to start vehicle / Service required" message
  • Driving, charging, and low-voltage support disabled
  • May correlate with wet weather, car washes, or A/C use

Likely causes (by probability)

  1. 1.Failing high-voltage accessory — PTC heater and A/C compressor are the usual suspectsHigh
  2. 2.Moisture in the charge port or onboard chargerMedium
  3. 3.Damaged high-voltage cable insulation (chafing, rodent damage)Medium
  4. 4.Drive inverter internal isolation failureLow

What you can check yourself

  • 01Note exactly what was running when it triggered — A/C, cabin heat, charging — that isolates the suspect component
  • 02Check for companion isolation alerts (bms_f142, bms_f158) to show the trend
  • 03Do not probe or disconnect any orange high-voltage components yourself
  • 04If it only appears in wet conditions, tell service — that pattern points to a specific leak path

EV systems involved in bms_f151_sw_external_isolation

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Shock-safety fault — do not drive. Tesla Service will isolate which external component is leaking; the pattern you observed helps them find it fast.

Estimated repair cost

Dealer / service center

— – —

Cost depends on the leaking component (heater/compressor are moderate; inverter is major) — covered under warranty where applicable, get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site