bms_u024_not_uncorked_capable
Safe to driveTesla · BMS system
Battery Management System — Vehicle Configuration Mismatch (Performance "Uncorking")
What it means
Tesla can electronically "uncork" certain cars to unlock extra performance, but the BMS has detected that the battery's current sensor hardware doesn't support the uncorked performance configuration the car is set to. This alert is mostly informational — the car drives fine on its standard configuration — but the mismatch needs a service correction.
Symptoms
- "Vehicle configuration mismatch — service needed" message
- No change in how the car drives or charges
- Often appears after a software update or configuration change
Likely causes (by probability)
- 1.Vehicle software configured for a performance level the battery hardware doesn't supportHigh
- 2.Incorrect vehicle configuration applied after service or a salvage/rebuild historyMedium
- 3.Battery or current sensor replaced with a different hardware revisionLow
What you can check yourself
- 01Verify the car's configuration history — especially if the car is used, rebuilt, or recently serviced.
- 02Note whether any performance features disappeared around the time the alert appeared.
- 03Schedule service; correcting the configuration is done with Tesla's Toolbox software, not at home.
EV systems involved in bms_u024_not_uncorked_capable
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
No safety issue and no rush, but only Tesla Service can reconcile the configuration. Book an appointment at your convenience.
Estimated repair cost
Dealer / service center
— – —
Usually a configuration/software correction rather than parts; cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a159_sw_hvp_ecu_errorBattery Management System — High-Voltage Processor Error Signal
- bms_f047_sw_memory_errorBattery Management System: Internal Memory Error
- bms_f141_sw_12v_pwr_supply_lowBattery Management System: 12V Power Supply Low
- bms_u029_dsoc_limitingBattery Management System — Maximum Charge Limited (Suspected Weak or Shorted Cell Group)