bms_a159_sw_hvp_ecu_error
Drive with cautionTesla · BMS system
Battery Management System — High-Voltage Processor Error Signal
What it means
The high-voltage processor has raised its hardware error line to the BMS — a hardwired "something is wrong with me" signal. High-voltage functionality was temporarily lost while the error was active. This is a service flag; if it keeps recurring, the HVP itself is suspect.
Symptoms
- Brief loss of high-voltage functions
- Silent center-display alert
- Possible momentary drive or charge interruption
- May recur at startup
Likely causes (by probability)
- 1.Internal HVP fault (power supply, processor, or driver circuit)Medium
- 2.Wiring issue on the error-signal line between HVP and BMSLow
- 3.Low-voltage supply glitch upsetting the HVPMedium
- 4.Software crash inside the HVPLow
What you can check yourself
- 01Note whether it was a one-time blip or repeats; recurrence is the key data point.
- 02Check low-voltage battery health — unstable 12V/16V supply upsets HV controllers.
- 03Keep software current; HVP firmware fixes ship in vehicle updates.
- 04Report any drive interruptions with date and time for log pulls.
EV systems involved in bms_a159_sw_hvp_ecu_error
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
A single occurrence that clears is usually benign. Recurring HVP errors deserve prompt service before high voltage drops out at a bad moment.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w100_hw_bmb_resetBattery Management System — Battery Monitoring Board (BMB) Reset Event
- bms_f018Battery Management System — Insulation / Isolation Monitoring Fault
- bms_a099_sw_bmb_communicationBattery Management System — Cell Monitor Communication Problem
- bms_f002_hw_over_voltageBattery Management System — Hardware Overvoltage Trip