bms_w079_sw_ctr_pwr_interrupted
Do not driveTesla · BMS system
Battery Management System — Contactor Power Interrupted
What it means
The BMS detected that power to the contactors was interrupted — and notes the battery's service disconnect may be pulled. With contactor power gone, the pack disconnects and the car can't drive, charge, or support the 12V system. A classic cause: the service disconnect (the manual safety plug used during repairs) was removed or is not fully seated.
Symptoms
- Car won't start or charge
- Often appears right after service work or a 12V disconnect
- May appear if someone accessed the battery service disconnect
Likely causes (by probability)
- 1.The high-voltage service disconnect is removed or not fully seatedHigh
- 2.Wiring/connector fault in the contactor power feedMedium
- 3.A fuse in the contactor supply circuit has blownLow
What you can check yourself
- 01Think about any recent service or inspection — an unseated service disconnect is the first thing for a technician to check.
- 02Do not attempt to remove or reseat the service disconnect yourself unless you are trained — it's part of the high-voltage system.
- 03Verify the 12V battery is connected and healthy.
- 04If no recent work was done, tow to Tesla Service for circuit diagnosis.
EV systems involved in bms_w079_sw_ctr_pwr_interrupted
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
The pack is electrically locked out. If this followed service work, call whoever did the work; otherwise tow to Tesla Service.
Estimated repair cost
Dealer / service center
— – —
If caused by recent service, the responsible shop should correct it at no charge. Otherwise diagnosis cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_u005_low_power_until_chargeBattery Management System: Reduced Power Until Charged
- bms_w047_sw_memory_errorBattery Management System — BMS Memory (Flash/RAM) Error
- bms_w153_sw_neg_contactor_weldedBattery Management System — Negative Contactor Welded Shut
- bms_a067_cac_imbalance_limitingBattery Management System — Cell Capacity Imbalance, Performance Limited