bms_w153_sw_neg_contactor_welded
Do not driveTesla · BMS system
Battery Management System — Negative Contactor Welded Shut
What it means
The negative main contactor has been detected as stuck or welded — its contacts fused, typically from opening under load. Like its positive-side twin, this is a core safety failure: the pack can't be disconnected on command. Driving, charging, and 12V support are blocked until the contactor is replaced and the alert manually cleared.
Symptoms
- Car won't start, drive, or charge
- History of power cutouts or over-current alerts possible
- Alert stays set until cleared with service tools after repair
Likely causes (by probability)
- 1.Contactor contacts welded by opening under high currentHigh
- 2.Aged/eroded contactor at end of lifeMedium
- 3.Sense-circuit fault giving a false welded readingLow
What you can check yourself
- 01Avoid restart attempts and any contact with the high-voltage system.
- 02Document the alert history for service.
- 03Arrange a tow — contactor replacement is sealed-pack work for Tesla Service.
EV systems involved in bms_w153_sw_neg_contactor_welded
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Same story as a welded positive contactor: internal pack repair, tow to service, no DIY option.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a078_rapid_dch_while_chargingBattery Management System — High Discharge Current During DC Charging
- bms_a165_sw_pack_partial_weldBattery Management System — One Pack Contactor Welded
- bms_f051_sw_current_sensor_miaBattery Management System: Current Sensor Missing (MIA)
- bms_f144_sw_cpld_version_wrongBattery Management System: CPLD Version Not Supported by Firmware