All codes

bms_w107_sw_cell_voltage_sensor

Do not drive

Tesla · BMS system

Battery Management System — Inaccurate Cell Voltage Measurement

What it means

The BMS has caught one or more cell groups reporting voltage measurements that don't add up — the readings are inaccurate rather than the cells necessarily being bad. Because charge control depends entirely on accurate cell voltages, the car may refuse to restart, drive, or charge until the sensing problem is resolved.

Symptoms

  • Car may not restart
  • "Service needed" warning
  • Unable to charge
  • May accompany odd state-of-charge or range behavior beforehand

Likely causes (by probability)

  1. 1.Faulty voltage-sense wiring or connector at a monitoring boardMedium
  2. 2.A failing battery monitoring board (BMB)Medium
  3. 3.A genuinely erratic cell group confusing the measurementLow

What you can check yourself

  • 01Photograph all alerts — the log data identifies which brick is misreporting.
  • 02Try one clean power-cycle and note if the same alert returns.
  • 03Check 12V battery health as a baseline step.
  • 04Voltage-sense circuits are inside the sealed pack — Tesla Service only.

EV systems involved in bms_w107_sw_cell_voltage_sensor

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Severity

Do not drive

Bad voltage data means the car can't charge or drive safely. One restart attempt, then arrange transport to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site