bms_w133_sw_service_tool
Safe to driveTesla · BMS system
Battery Management System — Invalid Request From a Service Tool
What it means
A connected diagnostic tool (like Tesla's Toolbox) sent the BMS a request that was malformed or not allowed in the car's current state, and the BMS refused it. The requested diagnostic function simply didn't run. This alert sets and immediately clears — it's a record of a service-tool interaction, not a vehicle fault.
Symptoms
- No symptom — log-only entry
- Appears only when diagnostic equipment was connected to the car
Likely causes (by probability)
- 1.A diagnostic command sent at the wrong time or in the wrong vehicle stateHigh
- 2.Third-party scan tool sending requests the BMS doesn't supportMedium
What you can check yourself
- 01Nothing to fix — if you were using a scan tool, note which action triggered it.
- 02If you weren't running any diagnostics when it logged, mention it at service.
EV systems involved in bms_w133_sw_service_tool
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Harmless log entry from a diagnostic session. No action needed.
Estimated repair cost
Dealer / service center
— – —
No repair needed — this records a diagnostic-tool interaction, not a fault.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a109_hw_bmb_mute_status_mismatchBattery Management System — Cell Monitor Mute State Mismatch
- bms_f007_sw_module_alarm_brokenBattery Management System — Module Alarm Circuit Not Working
- bms_f089_sw_thc_miaBattery Management System: Thermal Controller (THC) Missing
- bms_f179_replacesmartfuselimpBattery Management System: Pyro Fuse Past Service Life — Replacement Required