cp_a078
Safe to driveTesla · CP system
Charge Port — Door Mechanism / Position Sensor Fault
What it means
The motorized charge port door (or its position sensor) is not reporting the expected open/closed state.
Symptoms
- Port door opens/closes slowly, partially, or not at all
- Chime or alert about the port door
- Manual push needed to close
Likely causes (by probability)
- 1.Mechanism worn or obstructed by dirt/iceHigh
- 2.Position sensor driftMedium
- 3.Wiring to port door motorLow
What you can check yourself
- 01Clean around the door hinge area and cycle it several times.
- 02Check for ice in winter; preconditioning helps.
- 03Recalibration routines exist in service mode for some model years.
EV systems involved in cp_a078
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Deep dive: what owners should know
The motorized charge port door is a small luxury that owners stop noticing entirely — until the morning it opens two centimeters and stops, or closes with the enthusiasm of a sleepy eyelid, and CP_A078 lands in the alert history. The mechanism itself is simple: a small motor, a gear train, a position sensor that tells the controller where the door actually is. The failure space is equally simple, which is good news for owners. Dirt and ice account for the majority: the hinge and seal area collect road grime, and winter turns residual moisture into a door that moves in slow motion or judders mid-travel. The seasonal pattern — fine in October, cranky in January — is diagnostic gold when you are explaining the fault pattern to service. Cleaning the hinge area and cycling the door a dozen times restores many of them, as does preconditioning on frozen mornings before operating it. Position-sensor drift is the second family: the door moves correctly but reports a wrong position, and the controller, refusing to trust its own hardware, flags the mismatch. Some model years carry a recalibration routine reachable in service mode that re-learns the open and closed endpoints, worth finding before paying for parts. Physical wear — fatigued gears, a stripped actuator — is the terminal state, and on many models the mechanism or full port assembly is a replaceable part at sane prices. One warning worth repeating: a door that cannot close is not merely cosmetic. The open port invites water straight into the connector, and the next fault code you meet will be a far less friendly one.
Severity
Cosmetic/convenience unless the door cannot close (water ingress risk).
Estimated repair cost
Dealer / service center
$150 – $800
Mechanism or full port assembly.
DIY
$50 – $300
Mechanism parts on some models.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.