cp_a046
Safe to driveTesla · CP system
Charge Port — Communication Fault with Charging Equipment
What it means
The charge port controller lost its data link with the EVSE (wall charger) or with the car side during a session. Communication, not power, is the problem.
Symptoms
- Session starts then stops after seconds/minutes
- "Charging equipment not ready" messages
- Works on Supercharger but not home charger (or reverse)
Likely causes (by probability)
- 1.Wall connector / EVSE fault or firmware issueHigh
- 2.Damaged charge cable (proximity/pilot pins)Medium
- 3.Charge port controller glitchMedium
- 4.Grounding issue at the electrical installationLow
What you can check yourself
- 01Cross-test: different charger, different cable. Isolate which side fails.
- 02Power-cycle your wall connector / EVSE at the breaker.
- 03Have an electrician verify grounding if home charging specifically fails.
EV systems involved in cp_a046
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Deep dive: what owners should know
Charging an EV is a conversation, and CP_A046 means the conversation keeps dropping. Before a single electron flows, the charge port and the charging station exchange a precise protocol handshake: who are you, how much current can you deliver, is the cable seated, is the ground intact. Only when both sides agree does the contactors close and power flow. This code logs when that negotiation fails or collapses mid-session — and the distinction it encodes is between power problems and communication problems, which fail in completely different ways and point at completely different suspects. The diagnostic logic is a two-by-two. Try a different charger: if the car charges happily on a Supercharger but argues with your home wall connector, the car is exonerated and your EVSE is on trial — and wall connectors deserve suspicion, because their firmware, their breaker, and their installation grounding all participate in the handshake. Swap cables where the equipment allows it, since the pilot and proximity pins that carry the conversation live in the cable and wear with use. If every charger, everywhere, fails the same way, then the port controller and its wiring become the prime suspects, and a full power-off sleep of the car is the one free reset worth trying before booking anything. One environmental note: this code loves thunderstorms and brown-outs, because installation-side voltage sags mimic protocol failure. If the code appeared during a storm and never returned, that is the whole story.
Severity
Convenience issue only.
Estimated repair cost
Dealer / service center
$0 – $700
If the car side is fine, costs land on the EVSE side.
DIY
$0 – $200
Cable replacement or EVSE reset.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.