bms_a017_sw_brick_ov
Do not driveTesla · BMS system
Battery Management System — Cell Group Overvoltage
What it means
One or more "bricks" (groups of cells wired in parallel inside the pack) have exceeded the maximum safe voltage, so the BMS has stepped in to protect the battery. When this trips, the car can cut high-voltage power entirely — meaning no driving, no charging, and no support for the low-voltage system. This is the BMS preventing a genuinely dangerous overvoltage condition.
Symptoms
- "Unable to drive — Pull over safely" warning on the cluster
- Car may refuse to start or suddenly lose drive power
- Charging is disabled
- Single chime with a battery-cutoff warning
Likely causes (by probability)
- 1.A failing or damaged cell group drifting high in voltageHigh
- 2.Voltage sense wiring or battery monitoring board reporting bad readingsMedium
- 3.Charging system fault that overcharged part of the packMedium
- 4.BMS calibration or software errorLow
What you can check yourself
- 01Pull over safely and do not keep driving — the car may shut down high voltage at any moment.
- 02Do NOT attempt to open the battery pack or bypass any contactors; this is lethal high voltage.
- 03If you have Scan My Tesla or similar OBD logging, capture the brick voltages for the service technician.
- 04Note state of charge and whether the alert appeared during or right after charging.
EV systems involved in bms_a017_sw_brick_ov
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Park the car and call Tesla Service or roadside assistance. Overvoltage at the cell level is a real battery hazard — this one is not a DIY fix.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f068_sw_low_socBattery Management System: Critically Low State of Charge
- bms_f162_sw_fc_prechg_too_slowBattery Management System: Fast-Charge Precharge Too Slow
- bms_w024_sw_ctrs_open_under_loadBattery Management System — Battery Contactors Opened Under Load
- bms_w105_sw_one_module_tsenseBattery Management System — One Module Temperature Sensor Out of Range