bms_f162_sw_fc_prechg_too_slow
Drive with cautionTesla · BMS system
Battery Management System: Fast-Charge Precharge Too Slow
What it means
When a DC fast-charging session starts, the car precharges the bus through the fast-charge path — and this alert means the voltage rose too slowly, so the session was aborted. AC charging is unaffected; only Supercharging/DC fast charging fails.
Symptoms
- "Unable to DC fast charge / Disconnect and retry" message
- Supercharging session fails to start or aborts early
- AC charging works normally
Likely causes (by probability)
- 1.Fast-charge contactor or precharge path degradation in the carMedium
- 2.Supercharger station issue delivering unstable voltage at session startMedium
- 3.Charge cable or port connection resistanceLow
What you can check yourself
- 01Disconnect, wait a minute, and retry once — a single aborted session is often transient
- 02Move to a different stall or station; if it works elsewhere, the station was the problem
- 03Check whether AC charging still works normally to confirm the fault is DC-path-specific
- 04If every station fails, schedule service for the fast-charge contactor path
EV systems involved in bms_f162_sw_fc_prechg_too_slow
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
You can drive and AC charge normally — only DC fast charging is blocked. Rule out the station, then book service if it follows the car.
Estimated repair cost
Dealer / service center
— – —
Free if station-side; car-side fast-charge path work is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f123_sw_internal_isolationBattery Management System: Low Internal Isolation
- bms_u014_not_enough_pwr_to_heatBattery Management System — Not Enough Power to Heat the Battery While Charging
- bms_w059_sw_pack_voltage_sensingBattery Management System — Pack Voltage Doesn't Match the Sum of Cell Voltages
- bms_w162_sw_fc_prechg_too_slowBattery Management System — Fast-Charge Precharge Too Slow