bms_a068_cac_imbalance_limp
Drive with cautionTesla · BMS system
Battery Management System — Cell Capacity Imbalance, Limp Mode
What it means
This is the more serious sibling of the capacity-imbalance warning. The spread in cell-group capacities inside a module has grown large enough that the BMS has entered limp mode: maximum charge and discharge current are capped, usable energy is reduced, and both range and acceleration take a real hit.
Symptoms
- "High-voltage battery needs service — Acceleration and charging performance reduced" message
- Noticeably weaker acceleration
- Significantly reduced range per charge
- Slower charging, especially DC fast charging
Likely causes (by probability)
- 1.A genuinely failing cell group inside one moduleHigh
- 2.Progressive imbalance that was never addressed by earlier warningsHigh
- 3.Module-level damage from heat, impact, or manufacturing defectMedium
What you can check yourself
- 01Schedule service immediately — limp mode is the BMS telling you the pack needs professional attention, not a reset.
- 02Do a full AC charge with a long plugged-in rest so the technician has fresh balancing data.
- 03Log cell voltages via OBD if equipped; a clear outlier group supports a module repair vs. full pack decision.
- 04Do not attempt any pack-level repair or module swap yourself — lethal voltage and specialized tooling.
EV systems involved in bms_a068_cac_imbalance_limp
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Drivable but degraded. Get to Tesla Service soon — while under battery warranty, a confirmed failing module is often repaired or replaced at no cost.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w166_sw_ahtobecharged_imbalBattery Management System — Cell Group Charge Imbalance
- bms_a082_sw_ctr_force_openBattery Management System — Contactors Forced Open by Alert
- bms_a167_sw_fc_partial_weldBattery Management System — One Fast-Charge Contactor Welded
- bms_f054_sw_current_sensorBattery Management System: Current Sensor Fault