bms_w166_sw_ahtobecharged_imbal
Safe to driveTesla · BMS system
Battery Management System — Cell Group Charge Imbalance
What it means
The Battery Management System noticed that some cell groups in the pack need noticeably more energy than others to get back to full. In plain terms, the pack is out of balance — some sections are "fuller" than their neighbors. This alert is mostly a logging note and often clears on its own once the car finishes a balancing cycle.
Symptoms
- No obvious symptoms while driving
- Alert appears on screen with no chime and may disappear by itself
- Slightly longer time to reach a full charge
- Balance-related alerts may show up in service logs
Likely causes (by probability)
- 1.Normal pack imbalance that the BMS has not finished correcting yetHigh
- 2.Frequent short charging sessions that never give the pack time to balanceMedium
- 3.A genuinely weak cell group inside a moduleLow
What you can check yourself
- 01Charge to a high state of charge (above 90%) and let the car sit plugged in for several hours so balancing can run
- 02If you use Scan My Tesla, compare the highest and lowest brick/cell voltages at rest and note the delta
- 03Note when the alert appears (after DC fast charging, after storage, etc.) in case service asks
- 04Check for other BMS alerts active at the same time and make sure the car is on the latest software
EV systems involved in bms_w166_sw_ahtobecharged_imbal
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Severity
This is informational — you can keep driving normally. Give the car a long AC charging session so it can rebalance, and only worry if the alert keeps coming back.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w047_sw_memory_errorBattery Management System — BMS Memory (Flash/RAM) Error
- bms_w153_sw_neg_contactor_weldedBattery Management System — Negative Contactor Welded Shut
- bms_a067_cac_imbalance_limitingBattery Management System — Cell Capacity Imbalance, Performance Limited
- bms_a151_sw_external_isolationBattery Management System — External Isolation Fault