All codes

bms_a071_sw_sm_transcon_not_met

Do not drive

Tesla · BMS system

Battery Management System — State Change Blocked

What it means

The BMS was asked to change states — for example, to close the contactors and enable driving or charging — but a blocking condition stopped it. While the block is active, the car cannot drive, charge, or support the low-voltage system. This alert usually rides on top of another, more specific fault that is doing the actual blocking.

Symptoms

  • Car will not go into Drive or start a charge
  • Silent center-display alert, often alongside other BMS alerts
  • No low-voltage support from the high-voltage pack
  • May appear after a failed startup attempt

Likely causes (by probability)

  1. 1.Another active BMS alert (isolation, voltage, contactor) blocking the state changeHigh
  2. 2.Contactor or high-voltage interlock faultMedium
  3. 3.Software state-machine glitch that a full reset may clearLow

What you can check yourself

  • 01Look for other BMS alerts logged at the same time — this one is a symptom, the companion alert is the cause.
  • 02Try a full sleep cycle (park, lock, walk away 10+ minutes) and retry once.
  • 03Do not repeatedly force power cycles; if the block persists, stop and call service.
  • 04No high-voltage DIY — the blocking condition lives in the pack and contactor circuits.

EV systems involved in bms_a071_sw_sm_transcon_not_met

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

The car cannot drive while this is active. Check companion alerts, try one full sleep cycle, then arrange service or a tow.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site