bms_f077_sw_charger_regulation
Drive with cautionTesla · BMS system
Battery Management System: Charger Regulation Fault
What it means
During charging, the BMS targets a maximum brick voltage and a target charge current. This alert means the charger let the highest brick voltage or the charge current exceed its target for too long, so the BMS stopped the session to protect the cells. Charging is temporarily disabled until things settle.
Symptoms
- Charging session ends early or will not start
- Charge port light may flash amber
- Usually temporary — charging may work again after a pause
Likely causes (by probability)
- 1.Charger control loop overshooting voltage or current targetsMedium
- 2.One brick reaching full before the others (imbalance) near end of chargeMedium
- 3.Brick voltage sensing inaccuracy confusing the regulation loopLow
What you can check yourself
- 01Lower the charge limit to 80-90% and retry — if it only faults near 100%, imbalance is likely
- 02Let the car sit plugged in at high SOC so the BMS can balance the bricks, then try a full charge again
- 03Check brick voltages in Scan My Tesla at the moment charging stops
- 04If it faults at every charge level, suspect the charger hardware and book service
EV systems involved in bms_f077_sw_charger_regulation
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Severity
Usually a temporary stop, not a dead car. Retry at a lower charge limit; if it persists across sessions and chargers, schedule service.
Estimated repair cost
Dealer / service center
— – —
Often resolved by balancing or software; charger replacement is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w124_sw_bmb_comm_integrityBattery Management System — Communication Errors With a Battery Monitoring Board
- bms_a029_dsoc_limitingBattery Management System — Charge Voltage Capped (Cell Imbalance Protection)
- bms_a129_sw_vsh_failureBattery Management System — Voltage Sense Harness Fault
- bms_f018_sw_brick_uvBattery Management System: Brick Undervoltage